User Reported working SD cards (updated: 5th January 2022)Īll modern UHS-I U1 and U3 cards will generally work ok. Use foam pad to secure the board, you can also re-connect the battery. The locating key should slight protrude when the connectors are correctly installed. Once aligned squeeze the connectors together to their final position. Very carefully align the iFlash-ATA1 44-pin connector to the iPod connector and push to fully insert. Install the SD card in to the iFlash-ATA1, we are using an MicroSD card & adapter in this example. IPod should be ready to install the iFlash board and converter.ĭisconnect the Battery by pulling out the connector. Do not put too much stress on the HDD connector. Pry and release the headphone/hold switch connection.Ĭarefully remove the HDD from the HDD connector. Should work with majority of the Toshiba 44pin IDE hard drive using music players and devicesĬarefully pry open the iPod using suitable tools. (please note we do not official support these, so you are on your own!). User reports of other known working models The way the iFlash-ATA1 fits will cause greater stress on the hard drive ribbon. While the iFlash-ATA1 will work in the following 3rd gen models, we however suggest using our 4th Gen converter and iFlash-Solo for these models. Model Identifiers on case back: A1099, A1059, A1040 Models that are known to work :- Model Description 60Gb iPod 4th Gen – iFlash-Dual & 384GB installedįor use on iPod 4th Gen Color/Photo/Grey Scale/BW models.
0 Comments
Leave a Reply. |